The port forwarding set up is reliant upon the specific brand and model number of the router being used. Port forwarding of a router is required to allow access to your network device. Regardless of the 2 Wire Router being used, the process of port forwarding is similar. You willneed to enable the ports by locating the port range forwarding screen (Note: in many 2 wire systems, it is located in the firewall setting). The set up instruction outlined below is an example ofport forwarding a 2 Wire Router using 2 Wire Model 1800G.
Open your web browser.
Enter the router IP address 192.168.1.254 in the address bar as shown below, followed by pressing
Once logged into your router click on the “Firewall” tab on the top right.
For ‘Application Name’ give this entry a name e.g. Foscam Camera
For ‘Protocol’ Choose ‘TCP’
For ‘Port (or Range)’ in ‘From’ & ‘To’ enter the ports to be forwarded.
Example: 8090 to 8090
For ‘Protocol Timeout (seconds)’ & ‘Map to Host Port’ & ‘Application Type’ you can leave these all at their default values.
Click ‘Add Definition’
Repeat this step for all ports.
Once you have entered all the ports for this entry click ‘Back’
For ‘Select a computer’ choose the Foscam Camera’sIP address to forward the ports to.
Choose ‘Allow individual applications’
Choose ‘User-defined’ from the drop down box
In the list on the left choose the entry you created “Foscam Camera” and then click ‘Add’
Repeat this step for each entry you need to add.
Once you are all done click ‘Done’
Once you’ve done that, Foscam Camera should appear in the Hosted Applications
Click the Done button at the bottom right corner of the screen, and you should see the following screen:
To view the camera over the internet enter you router external IP address which can be found by typing www.whatismyipaddres.com into your browser.
Enter this IP address 22.214.171.1246: port for the camera (e.g. port 8090)
126.96.36.1996:8090 is what should be typed into you browser.